COVERiTe® is a Silane-Modifi ed Polymer based on -silane technology for the impregnation of substrates or as a thin layer colour coating.
COVERiTe® Has low odour, making it suitable for use in areas adjacent to those that are occupied.
COVERiTe® imparts high stain-resistance when applied as an impregnation or as a coating (e.g against stains like coffee, tea, ketchup, orange juice, ink, red wine, household and engine oils etc). Surfaces exhibit high strength, are exceedingly scratch-resistant and impervious to typical cleaning agents.
COVERiTe® contains no VOC’s which fully complies with the GBCSA’s requirements for a “Green” sealant.
COVERiTe® is resistant to moisture once cured.
COVERiTe® is UV stabilised and guaranteed not to yellow.
COVERiTe® is a 1 component system and does not require any additional catalysts.
COVERiTe® is available in 1kg, 2kg, 5kg, 10kg and 20kg plastic pails and are clearly labelled as such.
CEMENT-BASED SUBSTRATES:
- The substrate must be structurally sound.
- Free of loose granular particles.
- Free of excess dust.
- Dry – screed moisture levels must be below 3% using a VI-D4 Moisture meter and or below 75%RH.
- Free of any contamination, laitance, old adhesive, grease, oils, wax, sealers, and any substance that can inhibit adhesion.
- Further subfloor preparation information can be made available on request.
SCREED MOISTURE:
Should the screed moisture levels exceed that stipulated above, it is imperative that the substrate be prepared with VAPORiTe® Plus, or VAPORiTe® Premium depending on the application and complexity thereof. Further information pertaining to the correct product for the application can be made available on request.
SUBFLOOR SURFACE FINISH:
The subfloor surface should be of a good, fl at, smooth appearance. Due to the glossy characteristics of COVERiTe® all the imperfections in the subfloor will be highlighted.
It is highly recommended to apply COVERiTe® onto a surface prepared using LEVELiTe®.
COVERiTe® formulations whether for impregnation or coating, the surface must be dry and clean. To define the optimum amount and to check applicative behavior it is recommended to prepare a separate test surface. The material can be applied with a mohair roller or a brush. Airless spray application is equally possible. The open time of the formulation examples outlined here is ~ 20 min depending on temperature and humidity.
A second application (after 24 hours) will be necessary to attain a homogeneous finish. Depending on the absorbency behavior of the substrate ~ 50 – 150 g/m2 are typically required for the first layer. In the case of a second layer, by far a lower amount of material will be needed.
Tools and equipment must be washed with a solvent. It is not recommended to reuse the application tool such as rollers, but to use a new one for each coat or application.
Safety goggles and gloves should be worn to protect the eyes and skin from accidental exposure. In the event of eye contamination, the eyes must immediately be washed out with copious amounts of clean water, and medical assistance sought. It is recommended that overalls be worn to minimise soiling of clothing.
