iTe SLURRY® is a premixed single component product designed to promote bonding between LEVELiTe® and very smooth substrates. 

iTe SLURRY® is an essential keying agent in the application of LEVELiTe® over VAPORiTe ®+PLUS, as well  as over ceramic / porcelain tiles, epoxy coatings and smooth surfaces.  

iTe SLURRY® is water based and contains no VOCs which fully complies with the GBCSA’s requirements.

iTe SLURRY® is applied with a lamb’s wool roller at a rate of approximately 5.8m²/kg, when applied over  VAPORiTe®+PLUS. This yield may vary if applied over surfaces other than VAPORiTe ®+PLUS.

iTe SLURRY® must not be applied to surfaces where both surface and ambient temperatures are below  5oC. Stir the contents of the iTe SLURRY® bucket with an electric paddle mixer for 2 minutes. Apply a  thin coat onto the surface by means of a lamb’s wool roller. Allow to dry before applying LEVELiTe® to  the iTe SLURRY® surface as per our instructions as set out in the relevant data sheets. Should VAPORiTe  ®+PLUS form part of the system, ensure it is fully cured before iTe SLURRY® is applied. 

Depending on atmospheric conditions, iTe SLURRY® dries in approximately 30 to 45 minutes. Test the  dryness by scratching the iTe SLURRY®. No iTe SLURRY® should come off. It is imperative not to proceed  with the application of LEVELiTe® over the iTe SLURRY® before it is fully dried. 

Tools, equipment and soiled surfaces must be washed with water and a mild detergent immediately after

iTe SLURRY® must be stored in a cool dry place. 

iTe SLURRY® must be stored between 5°c and 30°c, and protected from frost, direct sunlight, and the  elements. 

iTe SLURRY® will last for 12 months unopened.